Could not load point cloud. Still a problem?

#1

New install recently. I’ve processed a few different projects and keep getting this error. No 3D model is generated the “Could not load point cloud. This task doesn’t seem to have one. Try processing the task again” message. I see where this was brought up back in October but I can’t find a solution.

Thanks for the help

#2

Hey @onetmat :hand: could you copy/paste a copy of your task output?

#3

I ran a fourth project tonight with same settings and the 3D model generated just fine. I have no clue why. The only difference was the project was flown at a higher altitude. Guess I’ll keep going and see if the problem persists. Thanks